המשלוח הוא לנקודת שירות (איסוף מחנות הקרובה לביתך)
השהיה בניתוק 6 שניות
Features:
-
This is a under-voltage switch module used to turn off the power of resistive load in the event of the voltage dropping below a definite value(set under-voltage).
-
If the voltage rises back in 6 seconds, the module will keep load turning on.
-
When the battery voltage increases to a certain value(set over-voltage), the module will automatically turn on load again.
-
Designed with a LED indicator to show if load is cut off or turned on.
-
Both under-voltage cut-off value and over-voltage turn-on value can be adjusted by simply pressing buttons.
Specifications:
Input Voltage: DC12V
Max. Current: 10A
Size: 50*48*20mm/1.96*1.89*0.78"
Instruction:
Load cut off and turn on:
For 12V storage battery, set under-voltage (load cut off voltage) as 10.5V, when the battery voltage drops to 10.5V or lower, controller will delay 6 seconds then cut off load. If voltage increases in the delayed 6 seconds, load will keep turning on.
Voltage setting:
Under the value setting condition as display flashes,
press start button to increase voltage,
and stop button to reduce voltage.
Start button function(setting under-voltage for cutting off load):
Under normal voltage display condition, press start button to display under-voltage value.
Press and hold start button till display flashes, then press start or stop button to set under-voltage value.
Stop button function(setting over-voltage for turning on load):
Under normal voltage display condition, press stop button to display over-voltage value.
Press and hold stop button till display flashes, then press start or stop button to set over-voltage value.
Restore to factory settings:
Press and hold start and stop button together till it
displays 888 to restore factory settings.
Note: When setting, if start voltage cannot be adjusted, you can adjust stop voltage first. This is not a circuit problem or program fault.
